Thu 27/02 | Lidar
Thursday, February 27, 2025
Room 3430, Experimantal Studio 1
MIT Media Lab | Put That There #
Myron Krueger | Videoplace, Responsive Environment, 1972-1990s #
Lidar | Hokuyo UST-10LX #
Basic Setup at Experimental Studio 1 #
- Make sure the power is on from the light switch near the door. Red light means ON
- Check that the lidar turns on.
- Connect the Ethernet cable from the sensor to your computer.
- Change the IP address of tour computer for the ethernet connection to be 192.168.0.X where X is a number greater than 10.